[. . . ] If the CHARGE lamp does not light up, check if the battery pack is firmly attached to this unit. When a fully charged battery pack is installed, the CHARGE lamp lights up once and then goes out. A battery pack that has not been used for a long time may take longer than usual to charge. [. . . ] The CHARGE lamp lights up and does not blink again: If the CHARGE lamp goes out because the charging time has passed, the problem is with the battery pack rst installed. The set is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet (wall socket), even if the set itself has been turned off. A moulded plug complying with BS 1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS 1362, (i. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. If you should lose the fuse cover, please contact your nearest Sony service station. For any service or guarantee matters please refer to the addresses given in separate service or guarantee documents. The BC-VM10 battery charger can only be used to charge an "InfoLITHIUM" battery pack (M series). This unit cannot be used to charge a nickel cadmium type or nickel metal hydride type battery pack. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local Civic Office, your household waste disposal service or the shop where you purchased the product. Please contact your nearest Sony dealer in connection with the product that may have a problem. [. . . ] 2 Connect the power cord (mains lead) to this unit and then to a wall outlet (wall socket) (See Illustration ). Remove the battery pack by sliding it in the opposite direction to when you attached it and lifting it straight out. For more about the battery life, see the instruction manual of your camera. [. . . ]